42515-EU-EN v4.5 5/14
4
Operating Instructions
IR (non-contact) Measurements
1. Hold the meter by its handle and point it toward the surface to be measured.
2. Pull and hold the trigger to turn the meter on and begin testing. The temperature reading, the
flashing ‘SCAN’ icon, the emissivity, and the unit of measure will appear. Note: Replace the 9V
battery if the display does not switch on.
3. Release the Trigger and the reading will hold for approximately 7 seconds (HOLD will appear on
the LCD) after which the meter will automatically shut off. The only exception to this is if the
TEST LOCK switch is set to ON.
Note: Select the temperature units (ºF/ºC) using the top switch inside the battery compartment
Backlight/Laser Pointer
1. While pulling the Trigger, push the backlight/laser button once to turn on the backlight.
2. Press it again to turn on the laser pointer. When the laser is ON the laser icon will appear in
the LCD.
3. Press the laser button to turn the backlight off.
4. Pressing it again turns the laser off.
Note: Backlight and Laser settings will be retained after the meter powers down.
Type-K (contact) Measurements
1. Plug the Type-K thermocouple sensor into the jacks at the bottom of the instrument. The jack
accepts a standard sub-miniature connector. Note that one plug spade is wider than the other
and the plug can only be inserted into the meter in one direction.
2. Pull the trigger to turn the instrument ON.
3. In order to keep the instrument’s power on while testing, the user can a:) hold the trigger or b:)
lock the instrument on by setting the center dip switch to the ON position (switches are located
inside of the battery compartment).
4. Repeatedly press the MODE button until the bottom display line of the LCD reads ‘T k’. The
temperature shown to the right of the ‘T k’ symbol is the temperature that the Type-K
thermocouple is sensing.
5. Hold the thermocouple in air or touch the tip of the sensor to the device that is to be tested. The
LCD’s bottom temperature display will provide the measurement value.
6. The supplied thermocouple is rated for 482
o
F (250
o
C).
(8 pages)
(13 pages)
(15 pages)
(8 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels