Extech Instruments SDL200 Guide de l'utilisateur télécharger pdf (Page 10)

10 SDL200-en-GB_V2.4 1/15

Battery Replacement and Disposal

When the low battery icon appears on the LCD, the batteries must be replaced. Several hours of

accurate readings are still possible in this condition; however batteries should be replaced as soon

as possible:

 Remove the two (2) Phillips screws from the rear of the meter (directly above the top of the tilt

stand).

 Remove and safely place the battery compartment and screws where they will not be damaged

or lost.

 Replace the six (6) 1.5V ‘AA’ batteries observing polarity.

 Replace the battery compartment cover with the two (2) Phillips screws.

Battery Safety Reminders

 Please dispose of batteries responsibly; always observe local, state, and federal regulations

with regard to battery disposal.

 Never dispose of batteries in a fire. Batteries may explode or leak.

 Never mix battery types. Always install new batteries of the same type.

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Extech Instruments SDL200 Guide de l'utilisateur Page 10